Toshiba e-STUDIO6520C Service Handbook page 428

[E071]Incorrect paper size setting for 1st drawer
[E072]Incorrect paper size setting for 2nd drawer
[E073]Incorrect paper size setting for 3rd drawer
[E074]Incorrect paper size setting for 4th drawer
[E075]Incorrect paper size setting for bypass tray
[E076]Incorrect paper size setting for bypass tray
Remove any paper which has jammed due to media type mis-setting and then confirm and set the
following:
* When this jam occurred during fax data printing, the user must place paper of the same media
type as that of the set paper. If the user does not have this media type, the media type setting
must be changed by means of the following codes.
08-9300: 1st drawer media type setting (*1)
08-9301: 2nd drawer media type setting (*1)
08-9302: 3rd drawer media type setting (*1)
08-9303: 4th drawer media type setting (*1)
08-9304: Tandem LCF media type setting (*1)
08-9347: Option LCF media type setting (*1)
(*1) 0: Plain paper, 1: Thick paper 1, 2: Thick paper 2, 3: Thick paper 3, 8: Recycled paper, 9: Plain
paper 1, 10: Plain paper 2
Cases media type setting change (08 code) is required
• When a drawer is set for fax data printing but the user does not have the media type set for the fax
drawer
• When no drawer is set for fax data printing but the user does not have any media type set for each
drawer
If the media type is correctly set but this error occurs frequently, this media type may be the one which
cannot be distinguished easily. In this case change the code below to disable the media type setting
checking function.
08-4598 0: Enabled 1: Disabled
[E090]Image data delay jam
1. Remove the paper remained in front of the registration sensor.
2. Check if the error is cleared by turning the power OFF and then back ON.
3. Check if the connectors connecting the SYS board, IMG board and LGC board are disconnected.
4. Check if the connectors connecting the IMG board and SLG board are disconnected.
5. Check if the connectors of the HDD are disconnected.
6. Check if the page memory is correctly connected to the connector on the SYS board.
7. Replace the page memory.
8. Replace the HDD, SYS board, IMG board and LGC board.
[E091]Motor on time-out jam
1. Check if there is any paper in the equipment. Remove it if there is.
2. If the error still occurs, check the following.
3. Check if the error is cleared by turning the power OFF and then back ON.
4. Check if the connectors connecting the SYS board, IMG board and LGC board are disconnected.
5. Check if the connectors connecting the IMG board and SLG board are disconnected.
6. Check if the connectors of the HDD are disconnected.
7. Replace the HDD, SYS board, IMG board and LGC board.
[E0A0]Image transport ready time-out jam
1. Remove the paper remained in front of the registration sensor.
2. Check if the error is cleared by turning the power OFF and then back ON.
3. Check if the connectors on the LGC board are disconnected.
4. Replace the LGC board.
e-STUDIO5520C/6520C/6530C
ERROR CODE and TROUBLESHOOTING
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 46