Toshiba e-STUDIO6520C Service Handbook page 41

Remark:
The buttons on the control panel keep blinking while data are being stored in the USB media.
• Do not disconnect the USB media while data are being stored.
• When the data of a code are printed again on the same equipment, the CSV file will be
overwritten because the names of these files contain the same serial number.
• PM support mode (6S):
<Operation procedure>
[6][START]
(Code)
[POWER]
2: PM Support Screen
• Firmware update mode (89): Refer to
• State transition diagram of self-diagnosis modes
Normal
[0][1]
Control panel
Warming up
check mode
Ready
[POWER]
OFF
*1
To user
*1 Turn OFF the power after using the self-diagnosis mode, and leave the equipment to the user.
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
[START]
(Operation started)
P.8-1 "8. FIRMWARE UPDATING".
[POWER]
ON
[0][3] [0][4] [0][5]
Adjustment
Test print
Test mode
mode mode
State transition diagram of self-diagnosis modes
Fig. 2-1
2 - 3
[POWER] OFF/ON
(Exit)
[0][8] [9][START] [6][START]
List print
Setting PM support
mode mode
mode
e-STUDIO5520C/6520C/6530C
SELF-DIAGNOSTIC MODE
[8][9]
Firmware
update mode
2