Hobart 5359D Operation And Maintenance Manual page 106

c
OM 2012
(3) Exe iter i!lstul la: ion
(a)
in5tuII 2xc ifer in accordance with TM.-360.
(b) Kcin:;ia II rear frarr~ mem!zr and tighton straws securely.
N O-E :
--
It may be necessury to use a iarge "C " c lamp or, other cxrang?-
r-rent to pi;l;ition frun;:: side rails end align rccr frame r;izriibci
mount ing holes .
D . Engine Co&-o1 Pane t
Tllc engine control panel is designed and mounfed in such a monnqr ihat it may Lz
re leased from Its mounted PCS it ion and tilted outward fcx access to components
mounted
cn
the back s Tde (see
Fig. 17).
(1) Tilt out engine control panel
,
(a) Remove clamp screw which supports w'ire conduit above output terminal
panel.
(b} Remove four capscrews which attach engine cot&o! pznei to frame sup%-
strut ture .
.
(c) Maneuver panel to tilt it inward at the bottom and outward at the top.
'
(2) Reinstall engine control panel
(a) Maneuver panel into po5 ition and align mounting holes. Install mounting
screw and secure.
(b) Secure wire conduit in its original pcxition with clamp and screw.
2-1
Aug2sa
Page 24