Replacing The Feed Stitch Motor - Janome MO200 Service Manual

MO200
5200QDC

REPLACING THE FEED STITCH MOTOR

REPLACING THE FEED MOTOR
TO REMOVE:
1. Remove the base cover (see page 3).
2. Remove the front cover (see page 5).
3. Disconnect the connector from the board "A".
4. Remove the snap ring (E-3).
5. Remove the two setscrews (A), (B) and remove the feed motor.
TO INSTALL:
6. To install the feed motor, follow the above procedure in reverse.
NOTE
Adjust the stretch stitch pattern feed balance (see page 16).
Setscrew (B)
Setscrew (A)
Feed motor (unit)
Snap ring (E-3)
31