Replacing The Feed Motor - Janome DC3018 Service Manual

REPLACING THE FEED STITCH MOTOR

REPLACING THE FEED MOTOR

TO REMOVE:
1. REMOVE THE FRONT COVER AND REAR COVERS (SEE PAGE 9~11).
2. REMOVE THE SNAP RING (E-3).
3. REMOVE THE TWO SETSCREWS AND REMOVE THE FEED MOTOR.
CUT OFF THE CORD BINDER.
TO INSTALL:
4. TO INSTALL THE FEED MOTOR, FOLLOW THE ABOVE PROCEDURE IN REVERSE.
NOTE
1. ADJUST THE STRETCH STITCH PATTERNS (SEE PAGE 21).
BINDER
FEED MOTOR
ACCESS SETSCREW (B)
THROUGH THIS HOLE
SETSCREW (B)
SNAP RING
(E-3)
28
SETSCREW (A)
SNAP RING (E-3)