Stretch Stitch Feed Balance - Janome MO200 Service Manual

STRETCH STITCH FEED BALANCE

When the number 8 is sewn 5 times with the feed balancing dial at the standard setting mark, the measurement
should be between 35.7 and 36.3 mm as shown.
ADJUSTMENT PROCEDURE:
1. Turn the power switch on while pressing the reverse button & auto-lock button.
Press the 8 button. (The standard mode shows up if you do not press the 8 button within 3 seconds.)
2. Set the feed balancing dial at standard setting mark
3. Sew 8 of number 8 and check if the measurement of five of them is between 37.7 and 36.3 mm.
4. Remove the cap and setscrew (A).
5. When the pattern is expanded, turn the adjusting screw counterclockwise "C".
When the pattern is blocked, turn the adjusting screw clockwise "D".
6. Attach the cap.
1. Turn the power switch on
while pressing the reverse
button & auto-lock button.
Standard setting
mark
Feed balancing dial
35mm
MECHANICAL ADJUSTMENT
2. Press the 8 button.
(The standard mode shows up if you do
not press the 8 button within 3 seconds.)
.
Setscrew
C
16
5200QDC
Cap
D
Setscrew (A)
MO200