Replacing The Feed Stitch Motor - Janome DC4030P Service Manual

DC4030P

REPLACING THE FEED STITCH MOTOR

REPLACING THE FEED MOTOR
TO REMOVE:
1. Remove the front cover and rear cover (see pages 4 and 5).
2. Remove the snap ring (E-3). Disconnect the connector from the board "A".
3. Remove the two setscrews (A), (B) and remove the feed motor.
TO INSTALL:
4. To install the feed motor, follow the above procedure in reverse.
NOTE
Adjust the stretch stitch feed balance (see page 15).
Setscrew (B)
Setscrew (A)
Snap ring (E-3)
30