Plate-Board-R Assy/Guide-Cable Power Low; Motor Fan (Low Voltage) - Toshiba e-STUDIO477S Service Manual

3.2.9 Plate-Board-R Assy/Guide-Cable Power Low

(1) Remove the scanner. (Refer to 3.2.6)
(2) Remove the Stay-R Assy. (Refer to 3.2.7)
(3) Remove the plate shield and take the CU/PU PCB out. (Refer to 3.2.8)
(4) Remove the six screws ① , and remove the three screws ② and remove the Plate-
Board-R-Assy ③ .
(5) Remove the three screws ④ , and remove the Guide-Cable Power Low ⑤ .
45387101TH Rev.1
②
③
①
6
②
⑤
②
④

3.2.10 Motor FAN (low voltage)

(1) Remove the scanner. (Refer to 3.2.6)
(2) Remove the Plate-Board-R-Assy. (Refer to 3.2.9)
(3) Remove the two screw(silver) ① and connector, and take the FAN (low voltage) ②
out.
Note! Be Careful to install the Motor-FAN in the direction.
3. Component replacement
3-9 /