Gas Operation - Dometic RMT 7650 Operating Instructions Manual

5.2.2

Gas operation

1. Open the valve of the gas cylinder.
2. Open the shut-off valve to the gas supply.
RMT 7650
A
RMT 7651 / RMT 7655
A
The ignition process is activated automatically, accompanied by a ticking sound
approx. 30 sec. Upon successful ignition, the display LED "C" "Gas" lights yellow.
The refrigerator is in function. Use rotary switch "B" to regulate the temperature in the
main refrigerator compartment.
- Repeat the entire process if the flame has gone out.
- Use rotary switch (B) to regulate the temperature in the main refrigerator compart-
ment.
All refrigerators, whether manual or automatic ignition, are equipped with
automatic flame protection, which automatically cuts off the supply of gas
approximately 30 seconds after the flame goes out.
When using for the first time, and after changing the gas cylinder, the gas
pipes may contain air. By means of brief operation of the refrigerator and
any other gas appliances (e.g. cookers), air is removed from the gas pipes.
The gas will then ignite without delay.
The refrigerator should only be operated using liquid gas
(Propane, Butane). Do not use Autogas, town gas or natural gas.
If the refrigerator is operated during travel using gas, the precautions
stipulated by the legislation in the respective country must be taken (in
conformity with the European standard EN 732).
Due to physical reasons, ignition faults could occur starting from an
altitude above sea level of approx. 1000 m /3280 ft. (No malfunction!)
As a basic rule, operation using gas is prohibited in petrol stations.
3. Set energy selector
switch "A" to gas.
5. Activate ignition
C
by pressing the
button (C) and
keep it depressed.
C
3. Set energy selector switch "A" to gas.
4. Set rotary switch "B" to "MAX" postion.
6. Once the flame has been ignited
9
4. Press and hold
rotary switch "B".
B
and is burning, the needle of the
galvanometer passes over into the
green section.