Installation Summary - Cisco Aironet 1130AG Series Hardware Installation Manual

Chapter 2 Installing the Access Point
The adjustable T-rail clip attaches to the mounting plate using four
A, B, and C holes on the T-rail clips and the mounting plate correspond to these T-rail widths:
•
•
•
Figure 2-4
Figure 2-4
1

Installation Summary

While installing the access point, you must perform the following operations:
•
•
•
•
•
•
•
OL-6226-01
C I S C O C O N F I D E N T I A L -
A holes—used for 1 1/2 in (38 mm) T-rails
B holes—used for 15/16 in (24 mm) T-rails
C holes—used for 9/16 in (15 mm) T-rails
indicates where you should push to open and close the adjustable T-rail clips.
Adjusting the T-Rail Clips
Push here to open
Open the access point cover (see
Mount the access point on a convenient flat horizontal or vertical surface, such as a desktop, book
shelf, file cabinet, wall, ceiling, or suspended ceiling T-rail (see the
section on page 2-9).
Attach the access point to the mounting plate (see the
Plate" section on page 2-16).
Connect Ethernet and power cables (see the
page 2-17).
Secure the access point (see the
Configure basic settings (refer to
Configure security and other access point options (refer to the Cisco IOS Software Configuration
Guide for Cisco Aironet Access Points).
D r a f t 2
2 Push here to close
"Opening the Access Point Cover" section on page
"Attaching the Access Point to the Mounting
"Connecting the Ethernet and Power Cables" section on
"Securing the Access Point" section on page
Chapter 3, "Configuring the Access Point for the First
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

Installation Summary

6x32x1/4 inch flat head screws. The
2-8).
"Mounting the Access Point"
2-19).
Time").
2-7