Power Supply - HP ProDesk 600 G3 Maintenance And Service Manual

Power supply

Description
Power supply, 180W, 92% efficient
Power supply, 180W, 85% efficient
WARNING!
replacement power supply provided by HP, or a power supply purchased as an accessory from HP should be
used with the computer.
The power supply is located at the rear of the chassis. It is held in place by three Torx screws outside of the
chassis and a release lever inside of the chassis.
WARNING!
outlet. To avoid possible personal injury and damage to the equipment the power cord should be
disconnected from the computer and/or the AC outlet before opening the computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the drive cage
4. From the outside, rear of the computer, remove the four Torx T15 screws that secure the power supply
to the rear of the chassis.
5. From the inside of the chassis, disconnect all power cables from the PWR (1) and PWRCMD (2) system
board connectors.
6. Press the release button at the front of the power supply (3).
To reduce potential safety issues, only the power supply provided with the computer, a
Voltage is always present on the system board when the computer is plugged into an active AC
(Access panel on page
(Drive cage on page
(Preparation for disassembly on page
21).
25).
20).
Power supply 49