Option Port - HP ProDesk 600 G3 Maintenance And Service Manual

Option port

A removable option port can be installed on the back of the computer.
To remove the option port:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the drive cage
4. From the inside of the chassis, remove the two Phillips screws that secure the assembly to the system
board (1).
5. Pull the option port assembly up to disengage it from the connector on the system board, and then
remove the assembly (2).
To install the option port connector assembly, reverse the removal procedures.
(Preparation for disassembly on page
(Access panel on page
(Drive cage on page 25).
21).
20).
Option port 55