Removing And Installing An M.2 Ssd Storage Card - HP ProDesk 600 G3 Maintenance And Service Manual

6. Connect the data cable (1) and power cable (2) to the rear of the hard drive.
NOTE:
system board labeled SATA0 to avoid any hard drive performance problems.

Removing and installing an M.2 SSD storage card

NOTE: The computer supports 2230 and 2280 M.2 SSD cards.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the drive cage
5. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
42 Chapter 4 Removal and replacement procedures: Small Form Factor
The data cable for the primary hard drive must be connected to the dark blue connector on the
(Access panel on page
(Front bezel on page
(Drive cage on page
(Preparation for disassembly on page
21).
22).
25).
20).