Removing And Installing An M.2 Ssd Storage Card - HP EliteDesk 800 G3 TWR Maintenance And Service Manual

5. Connect the power cable (1) and data cable (2) to the rear of the hard drive.
NOTE:
dark blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the
other end of the data cable to one of the light blue SATA connectors on the system board.
6. Reassemble the computer.

Removing and installing an M.2 SSD storage card

NOTE: The computer supports 2230 and 2280 M.2 SSD cards.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the drive cage
4. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
52 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
If the 2.5-inch hard drive is the primary drive, connect the other end of the data cable to the
(Access panel on page
(Drive cage on page
(Preparation for disassembly on page
20)
28)
19)