Installing The Neck - Star Trac E Series Install Manual

2. Installing the Neck

2a) Pop out the Front Motor Shroud Cap from the Motor
Shroud and remove the Neck Grommet and set it aside.
2b) Remove the Motor Shroud by removing the (2) #10 Truss
head screws.
2c) Insert neck as shown and fasten with (2) 5/16-18 x 3.0", (2)
5/16-18 x 1.0" socket head screws, (4) 5/16 washers and
(4) lock washers. DO NOT fully tighten yet.
2d) Route all cables through lower neck service opening into
motor compartment.
CABLES for cable routing and connection.
Refer to CONNECTING THE
Screws
Motor Shroud
Cap
Step 2a & 2b
Screws
Step 2c
Step 2d
STAR TRAC E SERIES TREADMILL
Motor Shroud
Install Guide