To Set The Hp-Ib Address - HP 86140A Series User Manual

To set the HP-IB address

1 Press the front-panel System key.
2 Press the More System Functions.... softkey.
3 Press the Remote Setup.... softkey. The Remote Setup panel appears.
4 The Current HPIB Address information shows the HP-IB address currently
5 Press the Set HPIB Address softkey if changes were made.
Setup panel
selections
Note
None of the Automeasure Setup parameters are affected by the front-panel Preset key.
They are not saved as part of the measurement setup.
being used. To change the address, use the numerical entry pad or knob to
change the New HPIB Address information. Press the Defaults softkey to reset
the address to factory preset defaults. Refer to
page 3-65 for information on changing and selecting items in the setup panel.
The Remote Setup panel
Current HPIB Address
Shows the HP-IB address currently being used.
New HPIB Address
Enter the new HP-IB address in the text box using the number keys or knob.
Using the Optical Spectrum Analyzer
The System Menus
"To Fill In a Setup Panel" on
3-55