Removing And Installing Timing Chain Covers (Left And Right) - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
10-cylinder direct petrol injection engine (5.2 ltr. 4-valve), mechanics - Edition 10.2013
17 - Timing chain cover (bottom)
❑ Removing and installing
Timing chain cover (left-side) - tightening torque and sequence
– Tighten bolts in 2 stages in the sequence shown:
Stage Bolts
1. -1 ... 8-
2. -1 ... 8-
Timing chain cover (right-side) - tightening torque and sequence
– Tighten bolts in 2 stages in the sequence shown:
Stage Bolts
1. -1 ... 8-
2. -1 ... 8-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Timing chain cover (bottom) - tightening torque and sequence
Note
Renew the bolts tightened with specified tightening angle.
– Tighten bolts for timing chain cover (bottom) in 6 stages as
follows:
Stage Bolts
1. -arrows-
2. -1 ... 11-
3. -arrows-
4. -2, 7, 8-
5. -1, 3, 4, 5, 6, 9, 10, 11- Turn 90° further
6. -arrows-
1.2 Removing and installing timing chain
covers (left and right)
Special tools and workshop equipment required
78
Rep. gr.15 - Cylinder head, valve gear
⇒ page 82
Tightening torque
Screw in by hand until contact is made
9 Nm
Tightening torque
Screw in by hand until contact is made
9 Nm
with respect to the correctness of information in this document. Copyright by AUDI AG.
Tightening torque/angle specification
5 Nm
8 Nm in diagonal sequence
11 Nm
22 Nm
Turn 90° further