Program Example For Resetting The Inverter At Inverter Error - Mitsubishi Electric FR-A7NC Instruction Manual

8.9 Program example for resetting the inverter at inverter error

The following is a program example for resetting
X0 X0F X1 SW80.0
0
M0 X101A X20
7
Error status flag
11
REMARKS
1. The above inverter reset using RY1A may be made only when an inverter error occurs.
Also, inverter reset can be made independently of the operation mode.
2. When using the instruction code execution request (RYF) with the instruction code (HFD) and data (H9696) to
reset the inverter, set a value other than "0" in Pr. 340 Communication startup mode selection (refer to page 22) or
change the operation mode to the network operation mode. (For the program example, refer to page 85)
3. Refer to page 37 for operation conditions of inverter reset.
PROGRAMMING EXAMPLES
station 1 inverter.
M0 Check the data link status of the station 1
Turn on the error reset request flag (RY1A)
Y101A
Turn off the error reset request flag (RY1A)
when the error status flag (RX1A) is off.
END
8
93