Problem solving guide
Faults in the water intake or water drain
Problem
Open water supply
Water intake
Drain
50
Possible cause and remedy
The water supply is turned off.
Turn on the water supply all the way.
Before fixing the fault:
Turn the commercial dishwasher off with the
button.
There is a problem with the water intake.
Turn on the water supply fully and start the
program again.
Clean the water intake filter (see "Maintenance").
The water pressure at the water intake is lower
than 30 kPa (4.4 psi).
Contact a plumber.
Before fixing the fault:
Turn the commercial dishwasher off with the
button.
Fault in the water drainage.
There might be water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kinks or high loops in the drain hose.