Mitel 6800 Series Administrator's Manual page 1020

Mitel 6800 Series SIP Phone Release 4.2.0 SP2 Administrator Guide
PARAMETER –
hardkeyN ring splash
DESCRIPTION
A-278
CONFIGURATION FILES
startup.cfg, <model>.cfg, <mac>.cfg
(6865i, 6867i, 6869i, and 6873i only)
When a key is configured for BLF or BLF/List functionality, this
parameter controls the ring splash alert pattern per key. The
following alerting patterns are available:
• 0: Silence (ring splash off).
• 1: Normal (same as current BLF ring splash).
• 2: Normal delayed (After a delay of [x] seconds, the ring signal
that is the same as the current BLF ring splash is played [use the
"ring splash delay" parameter to define the delay]).
• 3: Periodic (similar to the normal ring signal that is used by the
phone itself. The actual ring melody is based on the current
melody set for the line to which the BLF or BLF/List key is
associated).
• 4: Periodic delayed (same as Periodic but after a delay of [x]
seconds, the ring signal that is used by the phone is played [use
the "ring splash delay" parameter to define the delay]).
• 5: Low volume (same as the current BLF ring splash but at a lower
level to be less intrusive).
• 6: Low volume delayed (after a delay of [x] seconds, the ring
signal that is the same as the current BLF ring splash is played at
a lower level [use the "ring splash delay" parameter to define the
delay]).
• 7: The behavior is determined by the global parameter "play a ring
splash".
• If "play a ring splash" is defined as 0 then the feature is
disabled.
• If "play a ring splash" is defined as 1 then the behavior is the
same as Normal.
• If "play a ring splash" is defined as 2 then the behavior is the
same as Normal but the ring splash plays when idle and also
during the active call state.
• 8: In call delayed (same as Normal delayed but ring splash plays
when idle and also during the active call state [use the "ring splash
delay" parameter to define the delay]).
• 9: In call periodic (same as Periodic but ring splash plays when
idle and also during the active call state [use the "ring splash
frequency" parameter to define the ring splash frequency interval
for the active call state]).
• 10: In call periodic delayed (same as Periodic delayed but ring
splash plays when idle and also during the active call state [use
the "ring splash delay" parameter to define the delay for the active
and idle call state and the "ring splash frequency" parameter to
define the ring splash frequency interval for the active call state]).