Sunsmart 2.0 Wi-Fi Setup - Sundance Spas Kingston 980 Series Owner's Manual

12.8

SunSmart 2.0 Wi-Fi Setup

From the Settings Menu, tap
options, Figures 12.8a and 12.8b. Make sure that you have downloaded
the Wi-Fi App for this setup.
Note: A blinking Wi-Fi icon indicates that there is a communication is-
sue between the hot tub and router.
1. You need to follow the instructions from the App in order to connect
the Wi-Fi.
2. While the system attempts to connect you will see the, "SunSmart
Setup In Progress," Figure 12.8b. When the connection is done the
display will read, "SunSmart Setup Successfully Connected."
If the Wi-Fi connection setting should need to be
updated or connected to a new router, follow the steps
below.
1. From the "Settings" menu, tap
12.8a) to enter the menu.
2. Tap , Figure 12.8c. The display will change to
Reset
"Spa Wi-Fi Setup In-progress."
3. Tap
Reset
and allow the spa to connect to the new data.
4. Reconfigure and setup your spa by following the
instructions from the app.
System and Wi-Fi Router Requirements:
a. The hardware for the SunSmart 2.0 communicates over a 2.4 GHz
home network supporting 802.11b/g wireless technology.
Note: The system does not support 802.11 ac/n. If your Wi-Fi router
is either 802.11 ac or n, it may work with the module if it supports
802.11b/g. The hardware does not support 5 GHz networks.
b. Standard wireless setup supports only home network routers
configured to use open (no security) or WEP/WPA/WPA2.
c. Wi-Fi signal strength of -60 dBM or better is highly suggested to
ensure non-interrupted cloud service.
d. The wireless access is not supported on the following systems
• Guest networks/Hotspots that use a portal page to login.
SunSmart ...
Auto
6:45
SETTINGS
SunCooler ...
TM
Heat & Filter...
Water Care...
SunSmart ...
TM
Time & Date...
Figure 12.8a
again. This will clear the current data
to enter the programming
TM
Auto
6:45
SunSmart
TM
SunSmart Setup
In Progress...
Reset
Figure 12.8b
(Figure
SunSmart ...
TM
980™ Series
Auto
6:45
SunSmart
TM
SunSmart Setup
TM
In Progress...
Reset
Figure 12.8c
Page 51