Registration And Start-Up; Start-Up Sequence; Register Your New Spa - Sundance Spas Kingston 980 Series Owner's Manual

10.0 Registration and Start-up

10.1

Start-up Sequence

During the start-up sequence, the welcome screens will appear, Figure
10.1a. Then a blow out cycle will begin, page 48. After the cycle ends,
the hot tub will either display the Registration Menu or the Home Menu.
Note: The start-up menu will time out after approximately 3 seconds
and then change to the registration display in Section 10.2 (North
American models only) or to the Home Menu (page 31).
10.2

Register Your New Spa

Registering your spa is important in order to validate your
warranty. In order to register you will need to have the spa
serial number, Figure 10.2b, then you will need to register
online in order to receive a passcode. A passcode is only
given for North American models only. The passcode must
be entered into the control panel in order to unlock the
Registration Lockout screen, Figure 10.2a.
If the registration option is skipped (North American
models only), you will be able to activate components,
but after 10 minutes, the screen will revert back to the
registration screen. This process will continue until the spa is registered
and the passcode is entered.
Note: The spa will still protect itself if an error is detected.
To register your spa you need to have
your spa serial number. The best time
to retrieve the serial number is when
the spa is being connected. You must
register your spa via the internet at
www.SundanceSpas.com.
980™ Series
Figure 10.1a
Auto
6:45
LOCKOUT
Registration Lockout
Please register your spa at:
www.sundancespas.com/
owners/
warranty-registration.
Once registered, enter
your spa serial # and
registration passcode here:
enter #
Figure 10.2a
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB. SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
Power on Lamp on
serial
nameplate
Figure 10.2b
Page 29
later