Troubleshooting - Windsor Clipper Duo Operating Instructions Manual

Troubleshooting

PROBLEM
No Power, Nothing
Runs
Vacuum Motor Will Not
Run
Vacuum Motor Runs
But Suction Is Poor
Poor Or No Water Flow Pump switch in intermittent position.
(Carpet Is Streaky)
Brush Does Not Spin
CAUSE
Is the cord plugged in.
Circuit breaker tripped in building.
Faulty switch.
Faulty power cord or pigtail.
Vacuum circuit breaker tripped.
Faulty main vacuum switch.
Loose wiring.
Faulty vac motor.
Debris lodged in vac shoe.
Dome gasket defective or missing.
Vacuum hose cracked or hose cuff loose. Replace or repair as necessary.
Recovery tank full / float ball stuck in the
up position.
Jets clogged or missing.
Solution filter clogged.
Faulty solenoid.
Main switch off or in hand tool mode.
Brush circuit breaker tripped.
Brush belt broken.
Faulty brush motor.
86408790 Operator's Manual - Clipper Duo
SOLUTION
Plug in cord.
Reset breaker.
Call for service.
Call for service.
Reset breaker.
Call for service.
Call for service.
Call for service.
Remove debris from vac shoe.
Replace as necessary.
Turn off vac motor. Drain and rinse
recovery tank.
Turn to continuous or use buttons on
handle
Clean using a vinegar /water solution or
replace.
Drain solution tank and clean solution
filter.
Call for service.
Turn main switch to machine mode.
Reset circuit breaker.
Replace as necessary.
Call for service.
Maintenance
31