Figure 60. 3.5-inch simple-swap hard disk drive installation
b.
Gently push the drive into the bay until the drive stops.
Step 6.
Reinstall the drive bay filler panel that you removed earlier.
Step 7.
If you are installing additional simple-swap hard disk drives, do so now.
Step 8.
Turn on the peripheral devices and the server.
Removing the rear 2.5-inch hot-swap-drive kit
Use this information to remove the rear 2.5-inch hot-swap-drive kit.
To remove the rear 2.5-inch hot-swap-drive kit, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see "Removing the cover" on page 119).
140
Lenovo System x3550 M5 Installation and Service Guide
3.5-inch
simple-swap
hard disk drive
Release latch
Drive handle