Specifying Access Target When Mounted To Melsecnet/H Remote I/O Station - Mitsubishi QJ71MB91 User Manual

7
PARAMETER SETTING
7.3.5 Specifying access target when mounted to MELSECNET/H remote I/O
station
For the case where the QJ71MB91 is mounted to a MELSECNET/H remote I/O station,
the access target can be specified.
(1) To change the access target
Address
000E Access target (when mounted to MELSECNET/H remote I/O
H
(14) station)
7
- 29 7.3 MODBUS(R) Device Assignment Parameter

7.3.5 Specifying access target when mounted to MELSECNET/H remote I/O station

Set the access target as shown below.
Table7.12 Access target when mounted to MELSECNET/H remote I/O station
Parameter name
(a) When the access target is a remote I/O station ("0000
When the QJ71MB91 receives a request message from the master, the
MELSECNET/H remote I/O station device is accessed.
(b) When the access target is a remote master station ("0001
When the QJ71MB91 receives a request message from the master, a control CPU
device of the MELSECNET/H remote master station is accessed.
If the QJ71MB91 is not mounted on the MELSECNET/H remote I/O station, do not
make this setting. (An error will occur.)
Setting range
0000 : Remote I/O station
H
0001 : Remote master station
H
" is set.)
H
" is set.)
H
Default
0000
H