Chapter5 Functions; Function List - Mitsubishi QJ71MB91 User Manual

5
FUNCTIONS

CHAPTER5 FUNCTIONS

This chapter explains the functions of the QJ71MB91.

5.1 Function List

The function list of the QJ71MB91 is shown below.
Function
Automatic communication
Master function
Communication by dedicated
instructions
Automatic response function
*2
MODBUS
assignment function
Slave function
Link operation function
5
- 1 5.1 Function List
Table5.1 Function list
Automatically issues device read/write request messages from the
master (QJ71MB91) to a MODBUS
Allows reading/writing of MODBUS
*1
sequence program.
Automatically performs the processing corresponding to the
function code in the request message received from the master,
and automatically sends a response message.
Automatically converts access from the slave (QJ71MB91) to a
MODBUS
device
Users can assign any access destination.
*3
This allows direct access from the MODBUS
device to the programmable controller CPU device memory.
This function allows the master connected to QJ71MB91's CH1
(RS-232) communicate with several slave stations connected to
QJ71MB91's CH2 (RS-422/485).
If the link operation function is used, a RS-232 interface (1-to-1
communication) MODBUS
several MODBUS
* 1 Dedicated instructions are not available when the QJ71MB91 is installed to a MELSECNET/H
remote I/O station or a redundant system.
* 2 When the QJ71MB91 is mounted on a MELSECNET/H remote I/O station, there are restrictions on
the function codes supported by the automatic response function.(
* 3 When the QJ71MB91 is mounted on a MELSECNET/H remote I/O station, there are restrictions on
the assignment range of the MODBUS
Description
compatible slave device.
devices at any timing with a
device into access to a QCPU device.
master device can communicate with
slave devices.
device assignment function.(
Reference
Section 5.2.1
CHAPTER 10
Section 5.3.1
Section 5.3.2
compatible master
Section 5.3.3
Section 4.1 (3))
Section 7.3.1 (2))
(Continued on next page)