Restoring The Factory Default Settings - Pace RNG110 Installation Manual

MAKING USER SETTINGS (cont.)

Restoring the factory default settings

If you wish, you can restore the user settings to their factory defaults. All the changes you have made will be
lost and the settings will revert to those that were programmed in the factory.
The factory settings are:
USER/SUBTITLE SETTINGS menu item
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Configure Captions
Front Panel Settings
HDMI Settings
Subtitles
Subtitle Language
If you have not done so already, put the set-top into User Settings mode, as described on page 19.
1. Press the U or D button on the remote control and highlight Restore Defaults on the PACE USER
SETTINGS menu.
2. Press the R button. The message: "Restore Default. Press OK to confirm" appears on the TV screen.
(If, at this stage, you no longer wish to restore the factory settings, press the L button.)
3. To confirm and restore the factory settings, press the OK/Select button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 19 onwards. If you have finished
changing the settings, press the POWER button. The set-top then switches on with the restored settings.
If the set-top and HDTV are connected via a standard HDMI cable, the HDTV may pass information about
the required settings back to the set-top (see page 20). If you wish to restore the set-top's settings to
those created by the HDTV, you must disconnect the HDMI cable from the set-top before you restore the
factory default settings. When you reconnect the HDTV to the set-top via the HDMI cable, the HDTV will
pass back the information again.
Always turn off the set-top, then disconnect the set-top's power supply unit from the wall AC outlet
before you connect or disconnect any other equipment to or from the set-top's rear panel.
Options Factory default setting
– 16:9
1080i Yes
720p No
480p Yes
480i Yes
1080p24 Pass No
1080p30 Pass No
– No
– Off
Various All Auto except Hi Def CC, which is
Service 1
Standby Brightness Std
Viewing Brightness High
Audio Output Mode Auto
Disable Auto Detect No
– Off
– English
NOTES
RNG110 INSTALLER'S MANUAL (501-3438010)
24