Pace RNG110 Installation Manual page 5

SAFETY INFORMATION (cont.)
Safety aspects of connections
Full details of the rear panel are on page 7.
Connecting
Do not connect the set-top (or any other equipment such as a TV or VCR)
to the power supply until you have properly connected all the other cables.
The set-top is designed for use only with the supplied power supply unit.
On the power supply unit there is a label that specifies the correct AC
power supply input for it. Do not connect the power supply unit to any
supply other than this.
Always connect the 5 volt DC cord from the power supply unit to the
set-top before you connect the power supply unit to the wall AC outlet.
Disconnecting
To disconnect power from the set-top, always remove its power supply
unit from the AC mains supply (rather than disconnect the 5 volt cord from
the set-top).
Therefore you must install the set-top near to the wall AC outlet, which
should be easily accessible.
If you are in any doubt about the power supply cord, its plug or its
connection, consult a qualified electrician.
The CABLE IN connector is designed
for connection to a cable network only.
You must not connect any other
equipment, such as a VCR, to this
input.
5 volt cord
AC power cord
POWER INPUT
The model number, serial
number, and electrical
rating of this set-top are
on a label on its base.
5 volt power
supply unit
RNG110 INSTALLER'S MANUAL (501-3438010)
Regulatory information
CAUTION: Do not attempt to modify the set-top without written
authorization from the manufacturer. Unauthorized modification
could void your authority to operate the set-top.
The set-top has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. The set-top generates, uses
and can radiate radio-frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If the set-top does cause harmful interference to
radio or television reception, which can be determined by turning the
set-top off and on, you are encouraged to try to correct the interference
by one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the set-top and the receiver.
• Connect the set-top to an outlet on a circuit different from that to
which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
NOTE
5