Restoring The Factory Default Settings - Pace TDC788D User Manual

MAKING USER SETTINGS (cont.)

Restoring the factory default settings

If you wish, you can restore the user settings to their factory defaults. All the changes you have made will be lost
and the settings will revert to those that were programmed in the factory. The factory settings are:
PACE USER SETTINGS
menu item
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Configure Captions
Front Panel Settings
HDMI Settings
Language Settings
If you have not done so already, put your set-top into User Settings mode, as described on page 14.
1. Press the D button on your remote control until the front panel shows "reSt" (short for "restore factory
settings") and Restore Defaults is highlighted on the PACE USER SETTINGS menu.
2. Press the R button.
"YeS" appears on your set-top's front panel and the message: "Restore Defaults. Press OK to confirm"
appears on your TV screen. (If, at this stage, you no longer wish to restore the factory settings, press the
L button.)
3. To confirm and restore the factory settings, press the OK/Select button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 14 onwards. If you have finished
changing the settings, press the POWER button on your remote control. Your set-top then switches on
with the restored settings.
Options Factory default setting
– 16:9
1080i Yes
720p No
480p Yes
480i Yes
1080p24 Pass No
1080p30 Pass No
1080p60 No
– No
– Off
Various All Auto except Hi Def CC, which
is Service 1
Standby Brightness Std
Viewing TV Brightness High
Audio Output Mode Auto
Disable Auto Detect No
English English
Espagñol
Français
Português
TDC788D USER GUIDE (501-6D14300) E229
NOTE
If your set-top and HDTV are
connected via a standard HDMI
cable, your HDTV may pass
information about the required
settings back to your set-top (see
page 14). If you wish to restore
your set-top's settings to those
created by your HDTV, you must
disconnect the HDMI cable from
your set-top before you restore the
factory default settings. When you
reconnect your HDTV to your set-
top via the HDMI cable, your HDTV
will pass back the information
again.
Always turn off your set-top, wait
60 seconds, then disconnect your
set-top's power supply unit from
the wall AC outlet before you
connect or disconnect any other
equipment to or from its rear
panel.
Restore Defaults
Press OK to confirm.
21