Section 3 - Installation; Installing To A Feeder With A Power Pin; Installing To A Feeder With A Euro Or Bernard Power Pin - Bernard Q20 Series Owner's Manual

3-1 Installing to a Feeder with a Power Pin

3-2 Installing to a Feeder with a Euro or Bernard Power Pin

SECTION 3 - INSTALLATION

Euro Power Pin
Bernard Power Pin
1. Insert power pin to shoulder and
secure tightly.
2. Insert control plug into feeder.
3. Feed welding wire into power
pin by hand and tighten drive rolls.
1. Insert the Euro power pin to face of
receptacle. Thread Euro hand
nut clockwise to tighten.
1. Insert the Bernard power pin to face
of receptacle. Engage and rotate
locking sleeve to tighten
Page 8