Section 6 - Installation; Installing To A Feeder With A Power Pin; Installing To A Feeder With A Euro Or A Bernard ® Power Pin - Bernard Clean Air MIG Gun Series Owner's Manual

6-1 Installing to a Feeder with a Power Pin

1. Insert power pin to shoulder and secure tightly.
2. Insert control plug into feeder.
3. Feed welding wire into power pin by hand and tighten drive rolls.
6-2 Installing to a Feeder with a Euro or a Bernard
A. Euro Power Pin
1. Insert the Euro power pin to face of receptacle.
2. Thread Euro hand nut clockwise to tighten.
SECTION 6 — INSTALLATION
®
Power Pin
Figure 6-A
Figure 6-B
OM-CA-2.3 12