Table of Contents
Advertisement
COMPRESSED AIR can injure or kill
• Before working on compressed air system,
turn off and lockout/tagout unit, release
pressure and be sure air pressure cannot be
accidentally applied.
• Relieve pressure before disconnecting or
connecting air lines.
• Check compressed air system components and
all connections and hoses for damage, leaks
and wear before operating unit.
•
Do not direct air stream toward self or others.
•
Wear protective equipment such as safety glasses, hearing
protection, leather gloves, heavy shirt and trousers, high
shoes, and a cap when working on compressed air system.
•
Use soapy water or an ultrasonic detector to search for leaks
— never use bare hands. Do not use equipment if leaks are
found.
TRAPPED AIR PRESSURE AND WHIPPING
HOSES can injure
• Release air pressure from tools and system
before servicing, adding or changing
attachments or opening compressor oil drain
or oil fill cap.
H.F. RADIATION can cause interference
• High-frequency (H.F.) can interfere with radio
navigation, safety services, computers and
communications equipment.
• Have only qualified persons familiar with
electronic equipment perform this installation.
•
The user is responsible for having a qualified electrician
promptly correct any interference problem resulting from the
installation.
•
Have the installation regularly checked and maintained.
•
If notified by the FCC about interference, stop using the
equipment at once.
•
Keep high-frequency source doors and panels tightly shut,
keep spark gaps at correct setting, and use grounding and
shielding to minimize the possibility of interference.
ARC WELDING AND PLASMA CUTTING can
cause interference
• Electromagnetic energy can interfere with
sensitive electronic equipment such as
computers and computer-driven equipment
such as robots.
•
Be sure all equipment in the welding area is
electromagnetically compatible.
•
To reduce possible interference, keep cables as short as
possible, close together, and down low, such as on the floor.
•
Locate welding or cutting operation 100 meters from any
sensitive electronic equipment.
Page 5
•
Be sure welding machine or plasma cutter is installed
and grounded according to its Owner's Manual.
•
If interference still occurs, the user must take extra
measures such as moving the welding or cutting
machine, using shielded cables, using line filters, or
shielding the work area.
OVERUSE CAN CAUSE OVERHEATING
• Allow cooling period; follow rated duty cycle.
• Reduce current or reduce duty cycle before
starting to weld again.
• Do not block or filter airflow to unit.
Advertisement
Table of Contents
