About This Manual - Jet JWB-10 Operating Instructions And Parts Manual

25. Use the right tool at the correct speed and feed
rate. Do not force a tool or attachment to do a
job for which it was not designed. The right tool
will do the job better and more safely.
26. Use recommended accessories;
accessories may be hazardous.
27. Maintain tools with care. Keep saw blades
sharp and clean for the best and safest
performance. Follow instructions for lubricating
and changing accessories.
28. Disconnect tools before servicing and when
changing accessories, such as blades, bits,
cutters and the like.
29. Make sure the work piece is securely attached
or clamped to the table. Never use your hand to
hold the work piece.
30. Turn off the machine before cleaning. Use a
brush or compressed air to remove chips or
debris — do not use your hands.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible machine
damage.
This means that if precautions are not heeded, it may result in serious injury or possibly even death.
.

2.0 About this manual

This manual is provided by JET covering the safe operation and maintenance procedures for a JET JWDP-12 Drill
Press. This manual contains instructions on installation, safety precautions, general operating procedures,
maintenance instructions and parts breakdown. Your machine has been designed and constructed to provide
consistent, long-term operation if used in accordance with the instructions set forth in this document.
If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web
site: www.jettools.com.
Retain this manual for future reference. If the machine transfers ownership, the manual should accompany it.
Read and understand the entire contents of this manual before attempting assembly or
operation! Failure to comply may cause serious injury.
improper
SAVE THESE INSTRUCTIONS
31. Do not stand on the machine. Serious injury
could occur if the machine tips over.
32. Keep hands out of the line of saw blade.
33. Use a push-stick when required.
34. Pay particular attention to instructions on
reducing risk of kickback.
35. Never reach around or over saw blade.
36. Never leave the machine running unattended.
Turn the power off and do not leave the
machine until it comes to a complete stop.
37. Remove loose items and unnecessary work
pieces from the area before starting the
machine.
3