Loosen The Base Plate Of The On-Demand Heater; Pull The On-Demand Heater Assembly Out Toward The Top - Kärcher HDS 5/11 U Service Manual

5.9.5 Loosen the base plate of the on-demand heater

 Remove two screws on the base plate of the on-
demand heater.
1 Base plate for on-demand heaters
2 Screw
 Loosen the screw on the right of the on-demand
heater and swivel the holding plate to the side.
1 Screw
2 Holding plate
 Lift the electric box out of its holder by alternatingly
lifting it toward the top.
1 Electronics system
2 Top part of electric box
 Rest the electric box toward the front.
1 Electronics system

Disconnect the connector of the temperature con-
trol 95°C.
1 Socket plug connection
2 Electronics system
5.9.6 Pull the on-demand heater assembly out to-
ward the top.
 Place it behind the appliance.
 Unwind the mains cable and place it on the floor.
 Put one foot on the foot rest of the appliance.

Carefully lift the on-demand heater assembly by
the bow out of the floor group toward the top.

Lay the appliance down.
English 5.906-487.0 Rev. 00 (04/10)
25