Powered Adjustment In The Front / Perforated Plate In; The Rear - Invacare Dragon User Manual

Invacare® Dragon
Holding plate in lower position:
D
E
Holding plate in higher position:
Position of perforated plate: Seat height:
B
C
D
E
4.4 Powered adjustment in the front /
perforated plate in the rear
Consult the user manual for your remote for information
about powered adjustment.
In addition to the actuator under the seat in the front, the
Dragon with powered tilt also has two manual adjustment
plates in the rear. When combined, the powered tilt in the
front and the manual adjustment in the rear provide a wide
range of possible settings.
The total tilt adjustment range is from -4.5° to +25.5°. The
ability to set a negative tilt can be very useful as an aid in
getting out of the wheelchair.
• 3 mm Allen key
• 13 mm wrench
• Torque wrench
28
45 cm
45.5 cm
49 cm (at 6° seat angle)
47 cm
48 cm
50 cm
The picture above shows the position of the perforated
adjustment plates (1) and of the actuator (2) that allow
adjustment of seat height and tilt.
1.
To adjust the seat height / tilt, loosen and remove
screw (1).
2. Adjust perforated plate to desired height / angle.
3. Re-insert screw and tighten to 40 Nm.
1442477-R