Invacare Dragon User Manual page 27

The picture above shows the front perforated plates. The
procedure is similar for the rear perforated plates.
1. Loosen screw (1) to adjust seat height/angle.
2. Adjust perforated plate to desired height/angle.
3. Apply thread locking adhesive to screw, re-insert screw
and tighten to 40 Nm.
Seat height and angle can also be adjusted using the rear
holding plate.
• Low setting = hole combination 1 and 2.
• High setting = hole combination 1 and 3.
1442477-R
1. Loosen rear screw on one side (in bushing 1) so that
holding plate can be swivelled up or down.
2. Loosen front screw and remove. Depending on the
position, the screw is either in bushing 2 or 3.
3. Repeat procedure on other side.
4. Apply thread locking adhesive to screw, re-insert screw
and tighten to 25 Nm (+/- 3 Nm).
The swivelling rear perforated plates have five positions.
These are labelled in the illustration above with the letters
A to E.
All five positions can be used if the holding plates are in
the lower position (see above). Only positions B, C, D and
E are possible in the higher position! If position A is used,
there will be a collision between the holding plate and the
seat frames.
The following seat heights are available:
Holding plate in lower position:
Position of perforated plate: Seat height:
A
B
C
42.5 cm
44 cm
44 cm
Setup
27