Desk Mounting; Wall Mounting - BellSouth GH9457 Owner's Manual Installation And Operating Instructions

Desk Mounting

Desk Mounting
One of the special features of your telephone is the unique design of the MOUNTING BRACKET
which can hold your phone at an angle of 15° when desk mounting. There are two positions to
choose from:
1. NORMAL POSITION (MOUNTING BRACKET not required):
For normal position, as shown in Figure 1, place
the BASE UNIT on any desired but suitable
location.
2. 15° POSITION (See Figure 2):
With the back of the BASE UNIT facing up, insert
the hooks of the MOUNTING BRACKET (with the
position as shown in Figure 3) into the upper slots
of the BASE UNIT. Then slide the MOUNTING
BRACKET upward until it locks into place.

Wall Mounting

You may choose to put the BASE UNIT of your cordless telephone on a wall.
1. With the back of the BASE UNIT facing up, insert
the hooks of the MOUNTING BRACKET (with the
position as shown) into the lower slots of the BASE
UNIT. Then slide the MOUNTING BRACKET upward
until it locks into place.
2. Connect the SHORT TELEPHONE LINE CORD to the
TELEPHONE LINE CONNECTION JACK.
3. Plug the free end of the SHORT TELEPHONE LINE
CORD into the MODULAR WALL JACK.
4. Align the upper keyhole on the BASE UNIT with the
upper stud of the wall plate, so that the keyhole
opening on the MOUNTING BRACKET matches the
lower stud, then pull the BASE UNIT down until it is
securely seated.
FIGURE 1
FIGURE 3
SHORT TELEPHONE
LINE CORD
WALL PLATE
8
FIGURE 2
MOUNTING
BRACKET
MODULAR
WALL JACK
WALL PLATE STUD