Placing Calls; Redialing - BellSouth GH9457 Owner's Manual Installation And Operating Instructions

Cordless Telephone Operation

Placing Calls

1. Press the button, the Call Timer
starts to count.
2. Wait until you hear a dial tone and then
dial the phone number.
3. When you have finished your call,
press the button again or place the
HANDSET on the BASE UNIT.
OR
1. Dial the phone number.
2. Press the button. T h e n u m b e r
displayed will be dialed.
3. When you have finished with your call,
press the button again or place
the HANDSET on the BASE UNIT.

Redialing

1 . If you get a busy tone, press the
button or place the HANDSET on the BASE
UNIT to hang up.
2. Later, press the
3. Listen for a dial tone.
4. Press the /REDIAL button. This
SAVE
will automatically redial the last telephone
number you called.
5. When you have finished with your c a l l ,
press the button again or place
the HANDSET on the BASE UNIT.
NOTE:
If you are too far away from the BASE UNIT, the HANDSET emits "beep" sounds to
warn you that the background noise level is too high for proper communication between
the HANDSET and the BASE UNIT. When you hear this sound, you should move closer
to the BASE UNIT to reduce the noise level. Otherwise, the call will automatically cut off.
button again.
10
2 .4
G H z
1, 3
TALK
2 .4
G H z
1, 2, 5
TALK
4