Resolution Unit Selection For Printing; Paper Size Selection - Ricoh FAX4700L Service Manual

December 21st, 1995

2.2.13. Resolution Unit Selection for Printing *

The machine can use both inch and mm resolution units for printing. So, if the
resolution unit detection is enabled, the machine choose a right resolution
unit for printing as requested from the remote terminal in the protocol mes-
sage as shown in the follwing table.
Tx terminal's resolution unit
Resolution unit
detection
Cross reference
Resolution unit detection on/off - Printer switch 00, bit 7

2.2.14. Paper Size Selection *

If the machine has an optional cassette and/or an optional paper feed unit in-
stalled, the paper size to use is decided using the following rules.
•
If all the cassettes contain paper of the same size, the machine uses
the paper in the lower paper feed unit first, the paper in the upper paper
feed unit second, the paper in the 100 sheet cassette third, and the pa-
per in the standard cassette last.
•
If the received page has to be split up and printed on two pages, both
pages will be the same size.
•
If the cassettes contain different sizes, the paper size chosen for print-
ing the received fax message is selected in accordance with the follow-
ing table of priorities. The table assumes that reduction is enabled and
that the reduction ratio is 4/3.
Received Fax
Message Size
A5 Sideways
Letter
A4
F, F4
Legal
•
The paper size priority is graded from 1 to 5.
•
S: The data has to be separated and printed on more than one
page.
•
R: The data is reduced to fit on the printer paper.
•
Some of the reports can be printed on A5 paper without page sepa-
ration. However, if only A5 paper is in the cassettes, reports that
need larger paper sizes will require page separation.
ON
OFF
A5 sideways Letter
1
5(SR)
5(SR) 4(R)
5(SR) 4(R)
5(SR) 4(R)
DETAILED SECTION DESCRIPTIONS
Unknown
mm
inch
Selected Paper Size
A4
2 3
1 2
1
3(R)
3(R)
2-47
inch mm
inch mm
inch inch
F, F4
4
3
2
1
2(R)
PRINTING
Legal
5
4
3
2
1