Cisco Nexus 9000 Series Configuration Manual page 188

FEX QoS Configuration Example
• Policy map configuration:
switch# conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# policy-map type queuing inq_pri
switch(config-pmap-que)# class type queuing c-in-q3
switch(config-pmap-c-que)# priority level 1
switch(config-pmap-c-que)# class type queuing c-in-q2
switch(config-pmap-c-que)# bandwidth remaining percent 50
switch(config-pmap-c-que)# class type queuing c-in-q1
switch(config-pmap-c-que)# bandwidth remaining percent 30
switch(config-pmap-c-que)# class type queuing c-in-q-default
switch(config-pmap-c-que)# bandwidth remaining percent 20
switch(config-pmap-c-que)#
• Attach service policy to system target configuration:
switch# conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system qos
switch(config-sys-qos)# service-policy type queuing input inq_pri
• Verifying input queuing:
switch# show policy-map system type queuing input
switch# attach fex 101
fex-101# show platform software qosctrl port 0 0 nif 1
number of arguments 6: show port 0 0 2 1
--------------------------------------------------------
QoSCtrl internal info {mod 0x0 asic 0 type 2 port 1}
PI mod 0 front port 0 if_index 0x00000000
Media type 3
Port speed 10000
MAC addr 00:00:00:00:00:00
Port state: , Down
fabric_num 0, ctrl_vntag 0
ctrl_vlan 0, vntag_etype 0
Untagged COS config valid: no
Untagged COS dump:
rx_cos_def[0]=0, tx_cos_def[0]=0
rx_cos_def[1]=3, tx_cos_def[1]=3
Last queueing config recvd from supId: 0
-----SUP 0
Cisco Nexus 9000 Series NX-OS Quality of Service Configuration Guide, Release 7.x
174
Service-policy (queuing) input:
policy statistics status:
Class-map (queuing):
priority level 1
Class-map (queuing):
bandwidth remaining percent 50
Class-map (queuing):
bandwidth remaining percent 30
Class-map (queuing):
bandwidth remaining percent 20
ups 0 downs 0 binds 0
start -----
inq_pri
disabled (current status: disabled)
c-in-q3 (match-any)
c-in-q2 (match-any)
c-in-q1 (match-any)
c-in-q-default (match-any)
FEX QoS Configuration