Advanced Settings For Route Failover - D-Link NetDefendOS User Manual

accessibility of a host with this option set is mandatory.
Where multiple hosts are specified for host monitoring, more than one of them could have
Reachability Required enabled. If NetDefendOS determines that any host with this option
enabled is not reachable, Route Failover is initiated.
HTTP Parameters
If the HTTP polling method is selected then two further parameters can be entered:
• Request URL
The URL which is to be requested.
• Expected Response
The text that is expected back from querying the URL.
Testing for a specific response text provides the possibility of testing if an application is
offline. If, for example, a web page response from a server can indicate if a specific database is
operational with text such as "Database OK", then the absence of that response can indicate
that the server is operational but the application is offline.
A Known Issue When No External Route is Specified
With connections to an Internet ISP, an external network route should always be specified. This
external route specifies on which interface the network which exists between the NetDefend
Firewall and the ISP can be found. If only an all-nets route is specified to the ISP's gateway, route
failover may, depending on the connected equipment, not function as expected.
This issue rarely occurs but the reason why it occurs is that ARP queries arriving on a disabled
route will be ignored.

4.2.5. Advanced Settings for Route Failover

The following NetDefendOS advanced settings are available for route failover:
Iface poll interval
The time in milliseconds between polling for interface failure.
Default: 500
ARP poll interval
The time in milliseconds between ARP-lookup of hosts. This may be overridden in individual
routes.
Default: 1000
Ping poll interval
The time in milliseconds between sending a Ping to hosts.
Default: 1000
301
Chapter 4: Routing