Disc Playback 17 - Philips DVD741VR Owner's Manual

H9231CD(EN).QX3 02.9.5 7:13 PM
DVD
G
Before you begin, turn on the power of the TV, stereo receiver
and any other equipment connected to the DVD/VCR. Make
sure the TV and the stereo receiver (if applicable) are set to
the correct channel. Details are on pages 8-13.
1
Press POWER y y to turn on the DVD/VCR. "P-ON"
will appear briefly on the display panel.The DVD/VCR will
be in VCR mode.
2
Press OUTPUT SELECT so the red DVD light
appears on the front of the DVD/VCR.Then, press
DVD.
3
Press OPEN/CLOSE on the front of the DVD/VCR
to open the Disc tray.
4
Place a Disc into the tray.
Some DVDs are recorded on both sides. Make sure the
side you want to play is facing up. Or, if the DVD is record-
ed on only one side, place the Disc in the tray with the
label facing up.
5
Press PLAY B (o). The tray will close automatically, and
playback will begin at the first Chapter or Track of the
Disc.
Or, you may press OPEN/CLOSE or press the tray toward
the DVD/VCR to close the tray; DVD playback will start
automatically.
If a DVD menu appears instead, see page 48.
With some Audio CDs, playback will not begin unless you
press PLAY B (o).
6
Press STOP C (p) to stop playback. If Disc playback is
stopped for more than five minutes, a screen saver will
appear. Details are on page 75.
Remember, this DVD/VCR
will play only certain Discs.
See page six for details.
Page 17
AUDIO CD

Disc Playback 17

3
Press OPEN/CLOSE on
the DVD/VCR.
4
Insert a Disc.
POWER
MARKER
SETUP AUDIO SUBTITLE ANGLE
REC/OTR REPEAT REPEAT
A-B
CHANNEL/SKIP
CLEAR
TITLE MODE RETURN
2
OUTPUT SELECT
DVD VCR
DISC
MENU OK
6
STOP PLAY
REW FF
PAUSE
TIMER SET
1 2 3
VCR/TV
4 6
5
MEMORY
Helpful Hints
• An "X" may appear at the top right
corner of the TV screen when you
try a feature. Either the feature is
not available on the Disc, or the
DVD/VCR cannot access the feature
at this time.This does not indicate a
problem with the DVD/VCR.
• If a Disc is dirty or scratched, the
pictures may appear distorted or
playback may stop. Remove the
Disc and turn off the DVD/VCR.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the DVD/VCR again and
reinsert the Disc for playback.
• When the DVD or CD light appears
on the display panel, the Disc is
loaded completely and is ready for
playback.
• When you press OPEN/CLOSE or
PLAY (DVD) on the front of the
DVD/VCR when the power is off,
the DVD/VCR will turn on automati-
cally and will be in DVD mode.
1
5