Philips DVD741VR Owner's Manual page 35

H9231CD(EN).QX3 02.9.5 7:13 PM
4
Use the Number buttons (1-8) to select a slot in
which to store the timer recording. There are eight
slots. Numbers for open slots will flash on the screen.
NOTE: If you enter a number for a slot that has already been
used to store a timer recording, PREVIOUSLY SET PROGRAM will
appear on the screen briefly. Information about the program in
that slot will appear on the screen. If this happens, press DIS-
PLAY/STATUS/EXIT, then select another number.
5
Use the Number buttons to enter the TV channel
you want to record.
G
Cable TV Users, enter channel numbers as a two-digit
number for the quickest results. For example, to select
channel 6, press 0,6. If you only press the Number 6 but-
ton, channel 6 will be selected after a brief delay. There
also may be a brief delay when you select channels 10, 11,
and 12. If you want to select channels 100 and above,
enter channel numbers as a three-digit number. For
example, to select channel 117, press 1, 1, 7.
G
Antenna Users, enter channel numbers as a two-digit
number for the quickest results. For example, to select
channel 5, press 0,5. If you only press the Number 5 but-
ton, channel 5 will be selected after a brief delay.You may
only select channels 2-69.
G
If you are recording from line input, press 0,0 to select
AV REAR. See Helpful Hints below.
G
If you are using a Cable Box/DBS, select the Cable
Box/DBS output channel (03 or 04). Set the Cable
Box/DBS to the channel you want to record. Leave the
Cable Box/DBS on for the timer recording. Details
are on page nine.
6
Press two Number buttons for the hour you want
the recording to begin. Press two Number buttons
for the minute you want the recording to begin.
Press 1 for AM or 2 for PM. For example, for 9:30 PM,
press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM
CHANNEL
TIME ON
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
7
Follow the instructions in step 6 to enter the record-
ing's stop time. (AM or PM will be set automatically.)
ONE TIME PROGRAM
PROGRAM
CHANNEL
TIME ON
TIME OFF
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
Instructions continue on page 36.
Page 35
1
10
– – : – –
1
10
09:30 PM
– – : – –
Timer Recording (cont'd) 35
4-7
MARKER
SETUP
REC/OTR
TITLE
DVD
DISC
MENU
STOP
REW
1
4
7
+ 10
SEARCH MODE DISPLAY
TIME SEARCH
Helpful Hints
• Entries that do not match the
DVD/VCR's clock or calendar will
cause a question mark to appear
on the screen.
• If you are recording from line input,
connect the audio and video cables
to the AUDIO IN and VIDEO IN
jacks on the back of the DVD/VCR.
(Please see illustration on page 38.)
• The +10 Number button has no
effect in VCR mode, so do not use it
to enter TV channel numbers at
step 5.
POWER
AUDIO SUBTITLE ANGLE
REPEAT REPEAT
A-B
CHANNEL/SKIP
CLEAR
MODE RETURN
OUTPUT SELECT
VCR
OK
PLAY
FF
PAUSE
TIMER SET
2 3
VCR/TV
5 6
MEMORY
8 9
SPEED
0
ZOOM SLOW
STATUS/EXIT