Configure - Emerson Rosemount 2051 Quick Start Manual

September 2016

7.0 Configure

Each F
OUNDATION
displaying and performing configurations. Some use device descriptions (DD) or
DD methods for configuration and to display data consistently across platforms.
There is no requirement that a host or configuration tool support these features.
Use the following block examples to do basic configuration to the transmitter. For
more advanced configurations, see the Rosemount 2051
Note
™
DeltaV users should use DeltaV Explorer for the Resource and Transducer blocks and
Control Studio for the Function Blocks.
7.1 Configure the AI block
If your configuration tool supports Dashboard DD's or DTM's you may use either
guided setup or manual setup. If your configuration tools don't support
Dashboard DD's or DTM's, use manual setup. Navigation instructions for each
step are provided below. In addition the screens used for each step are shown in
"Basic Configuration Menu Tree" on page
Figure 9. Configuration Flowchart
Start
Device Configuration
Here
Fieldbus host or configuration tool has a different way of
1. Verify Device Tag:
PD_TAG
2. Check Switches and
Software Write Lock
3. Set Signal
Conditioning:
L_TYPE
4. Set Scaling
XD_SCALE
5. Set Scaling
OUT_SCALE
Reference
14.
6. Set Low Cutoff:
LOW_CUT
7. Set Damping:
PRIMARY_VALUE_
DAMPING
8. Set up LCD Display
9. Review Transmitter
Configuration
10. Set Switches and
Software Write Lock
Quick Start Guide
Manual.
Done
13