Running The Remote Desktop Software - Fujitsu PRIMERGY TX100 S2 Core Edition Operating Manual

– Connect by IP address
If DHCP is not available on your network or if your server is directly
connected to the client computer the following default network settings
are applied:
Default IP address:
Default subnet mask:
Default gateway:
Ê Configure your client's static IP address on subnet 192.168.10.x with
subnet mask 255.255.255.0.
Example: 192.168.10.20
Subnet mask: 255.255.255.0
For further details on how to configure network settings, refer to
section "Network configuration (optional)" on page
V
– It is highly recommended to take note of the original
– Ensure that the IP address is not your server's default
I
The subnet mask is used by the TCP/IP protocol to determine
whether a host is on the local subnet or on a remote network.
5.2.3.2

Running the Remote Desktop software

Ê On your client computer, click Start, point to All Programs, and then point to
Accessories.
Ê In the Accessories menu, point to Communications, and then click Remote
Desktop Connection.
I
If the Remote Desktop Connection shortcut is not listed in the start menu
at the specified location, proceed as follows:
Ê On your client computer, click Start, point to Run, and then type
mstsc in the Open box.
Ê Click OK.
TX100 S2 Core Edition
192.168.10.10
255.255.255.0
192.168.10.1
network setting values (e.g. IP address, subnet mask,
default gateway) before altering the network configuration.
address (192.168.10.10) and is not otherwise in use on the
network.
Operating Manual
Installation and operation
52.
49