Installing and Managing Power over Ethernet (PoE)
Monitoring Power over Ethernet via CLI
To monitor current PoE statistics and settings, use the
displays a list of all current PoE-capable, along with the following information for each port:
Maximum power allocated to the port, in milliwatts
•
Actual power used by the port
•
Current port status
•
Power priority status
•
Power on/off status
•
Aggregate slot and chassis management information is also displayed. This information includes:
Maximum watts allocated to the corresponding slot
•
Amount of power budget remaining that can be allocated for PoE modules
•
Total amount of power remaining that can be allocated for additional switch functions
•
When entering the show lanpower command, you must include a valid slot number in the command line
syntax. For example:
-> show lanpower 1
-> show lanpower 1
Port Maximum(mW) Actual Used(mW)
----+-----------+---------------+-----------+---------+------+-------
1
15400
2
15400
3
15400
4
15400
Slot 1 Max Watts 66
66 Watts Total Power Budget Remaining
66 Watts Total Power Budget Available
2 Power Supplies Available
Note. For detailed information on show lanpower command output, refer to the OmniSwitch CLI Refer-
ence Guide.
OmniSwitch 6855 Series Hardware Users Guide
show lanpower
Status
0
Undefined
0
Undefined
0
Undefined
0
Undefined
March 2009
Monitoring Power over Ethernet via CLI
command. The command output
Priority
On/Off
Class
Low
OFF
None
Low
OFF
None
Low
OFF
None
Low
OFF
None
page 6-11