Setting The Winder - DURKOPP ADLER 867-M PREMIUM Service Instruction

Winder

14.2 Setting the winder

Fig. 52: Setting the winder (1)
(1) - Screws
(2) - Screw
Proper setting
The winder wheel runs smoothly and without axial play.
The winding process will stop automatically when the required filling quantity
of the bobbin is reached.
To set the winder:
1. Remove the arm cover ( p. 17).
Removing the winder
2. Loosen the screws (1).
3. Remove the winder.
Setting the winder filling quantity
The position of the arms (4) on the winder lever (3) determines the filling
quantity:
4. Turn the screw (2):
5. Put the completely filled bobbin onto the winder.
6. Fold the winder lever (3) upwards as far as it will go to the thread.
Service Instructions 867-M PREMIUM - 02.0 - 02/2017
①
②
• Parallel: Automatic winding stop at 0.5 mm below the edge of the
winder
• Closer together: Automatic stop with larger filling quantity
• Further apart from each other: Automatic stop with smaller filling
quantity
• Arms (4) closer together: turn counterclockwise
• Arms (4) further apart from each other: turn clockwise
③
(3) - Winder lever
(4) - Arm
④
65