Setting The Locking Latch - DURKOPP ADLER 867-M PREMIUM Service Instruction

16.2 Setting the locking latch

Fig. 65: Setting the locking latch
(1) - Locking latch
(2) - Roller
(3) - Control cam
To set the locking latch:
1. Loosen the nut (4).
2. Turn the screw (5) and adjust the distance.
3. Tighten the nut (4).
Checking the setting of the locking latch
To check the setting of the locking latch:
1. Turn the handwheel until the roller (2) is at the highest point of the
2. Press the roller (2) against the control cam (3).
 The locking latch (1) can be swung out without clamping.
78
①
②
③
control cam (3).
The distance between the locking latch (1) and locking pin (6) is not
greater than 0.1 mm.
Short thread cutter
(4) - Nut
(5) - Screw
(6) - Locking pin
Service Instructions 867-M PREMIUM - 02.0 - 02/2017
⑥
⑤
④