Installing A Plim Or Sip - Cisco ASR 14000 Series Hardware Installation Manual

Chapter 5 Installing and Removing a PLIM or a SIP
Figure 5-4
1
2
1
2
3

Installing a PLIM or SIP

This section provides step-by-step instructions for installing a PLIM or SIP. You can install a PLIM or
SIP in any slot not occupied by a route processor (RP) card. If you install a new FP40 or SIP, you must
first remove the PLIM impedance carrier card from the available slot.
Caution The system can indicate a hardware failure if you do not follow proper procedures. Remove or install
only one SIP or PLIM at a time. Allow at least 15 seconds for the system to complete the preceding tasks
before removing or installing another SIP or PLIM.
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
OL-17456-01
Removing or Installing a PLIM or SIP
3 3
0
3 3
0
Captive screw
Ejector lever
Septum
Cisco ASR 14000 Series Router PLIM, SIP, and SPA Hardware Installation Guide
4
3
0
SP A
SP A
BA Y
BA Y
3
0
SP A
SP A
BA Y
BA Y
4
1
3
SP A
SP A
BA Y
BA Y
5
2
5
5
2
4
4 Guide pins
5 Direction of installation or removal
PLIM or SIP Installation and Removal
5-5