Chapter 5 Installing And Removing A Plim Or A Sip; Handling Plim Or Sip - Cisco ASR 14000 Series Hardware Installation Manual

Installing and Removing a PLIM or a SIP
This chapter describes how to install or remove PLIM or SIP on the Cisco ASR 14000 Series Router.
This chapter contains the following sections:
•
•
•

Handling PLIM or SIP

Each PLIM or SIP is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD) damage.
Before you begin installation, read
parts and tools required for installation.
Always handle the PLIM or SIP by the carrier edges and handle; never touch the PLIM or SIP
Caution
components or connector pins (see
Figure 5-1
OL-17456-01
Handling PLIM or SIP, page 5-1
Guidelines for PLIM or SIP Installation and Removal, page 5-3
PLIM or SIP Installation and Removal, page 5-4
Handling a PLIM or SIP
Printed circuit board
Metal carrier
GND
Cisco ASR 14000 Series Router PLIM, SIP, and SPA Hardware Installation Guide
C H A P T E R
Chapter 4, "Preparing to Install a PLIM, SIP, and SPA,"
Figure 5-1).
5
for a list of
5-1